Filter
Top Products
9 (US)
Step 4:
Prepare for the
installation of the TV
1 Remove the screws that hold the
TV to the Tabletop Stand.
2 Detach the TV from the Tabletop
Stand, and place the TV, with its
screen facing down on a Stable,
cloth-covered work surface, at
least 20 cm (8 in.) off the floor.
Note
Be sure that two or more persons hold the TV when
carrying it. Do not hold the transparent parts at either
the top or bottom of the TV.
2 Adjust the angle of the stabilizer
arms.
When installing the TV perpendicularly (0
degrees), adjustment of the arms angle
(Procedure 1 and 2 below) is not necessary.
Make sure that each stabilizer arm is screwed in
securely.
1 Remove the screws that are at the top and
bottom center of the both stabilizer arms.
Then choose the notch corresponding to the
desired angle (5,10,15 or 20 degrees) and fit
the stabilizer arm to it.
2 Firmly secure each stabilizer arm using the
screws removed in Procedure 1.
Notes
• Be sure to adjust the angles of the right and left
arms to the same angle.
• Be careful not to pinch your fingers when adjusting
the angle of arms.
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m.
2
1
•0 degrees: Leave the white screws tightened as they
are.
• Other than 0 degrees: Remove the white screws.
Stabilizer arm
Clamp screw