Filter
Top Products
7 (US)
Step 2:
Decide on the
installation location
1 Place the paper template on a
perpendicular, flat wall and
decide on the installation
location.
Tape the supplied 3 sheets of the paper template
together with commercially available adhesive
tape. For details, refer to the instructions printed
on the paper template.
Allow for suitable clearance between the TV and
the ceiling and protruding parts of the wall as
shown in the diagram below.
Note
If you intend to route the cables in a wall, make a hole
in the wall beforehand to make sure that the cables
can be drawn into the wall. The position for the cable
hole is printed on the paper template and on page 17.
Unit: mm (inches)
100
(3
15
⁄
16
)
100
(3
15
⁄
16
)
100
(3
15
⁄
16
)
300
(11
13
⁄
16
)
Step 1:
Check the parts
required for the
installation
1 Prepare a Phillips screwdriver
and the appropriate screws (four
or more M8 (or equivalent)
screws, not supplied),
depending on the material of
the wall, beforehand.
2 Open the package and check the
parts.
Hook (4)
Paper Template
(1 set of 3 sheets)
Screw (+PSW5 × L14) (6)Screw (+B6 × L20) (4)
Mounting Rack (1)
Plate Unit (1)
Woofer Speaker