Filter
Top Products
10 (GB)
If you intend to install a TV that is not specified on page 2, be
sure to refer to the leaflet “Installing the Wall-Mount
Bracket” supplied with your TV.
Step 6:
Installing the TV on the
wall
WARNING
Be sure to complete the installation before connecting the
AC power cord to the wall outlet. If you allow the AC
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV, as you may hurt yourself.
1
Connect the AC power cord and
the connecting cable(s) supplied
with the TV to the TV.
Connect the AC power cord and the connecting
cable(s) to the connectors on the rear of the TV. For
details on connecting the AC power cord and the
connecting cable(s), refer to the instruction manual of
the TV.
Notes
• You cannot connect the cables to the TV after installing it
on the Base Plate.
• Subcontract the cable routing in the wall to a licensed
contractor.
2
Install the TV onto the Base
Plate.
1 Referring to the Hook locations diagram/table on
page 13, determine the holes of the Base Plate for
latching the upper hooks of the Mounting Hook.
2 Hold the TV securely with both hands, and gently
align it on the wall.
3
Firmly secure the TV and the
Base Plate using the two
supplied screws (+PSW4 × 12).
Secure the screw to the same angle mark that you
adjusted in 3 of Step 5.
Note
When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
12
Mounting Hook
Holder
Mounting Hook
Base Plate
Screw
(+PSW4 × 12)
WARNING
Be sure to tighten both left and right securing screws
firmly. If you fail to do so, the TV may fall when it is
pushed upward and cause injury.