Sony TRV80 DVR User Manual


 
16
Charging the battery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the “InfoLITHIUM” battery pack (M series).
See page 197 for details of “InfoLITHIUM” battery pack.
(1) Install the battery pack on your camcorder.
(2) Connect the AC Adaptor supplied with your camcorder to the DC IN jack with
the DC plug’s v mark facing up.
(3) Connect the power cord to the AC Adaptor.
(4) Connect the power cord to a wall outlet.
(5) Set the POWER switch to OFF (CHG). Charging begins. The remaining battery
time is indicated in minutes in the display window.
When the remaining battery time indicator changes to , normal charge is complete.
To fully charge the battery pack (full charge), leave the battery pack attached for about
one hour after normal charge is complete until the FULL indicator appears in the
display window. Fully charging the battery pack allows you to use the battery pack
longer than usual.
After charging the battery pack
Disconnect the AC Adaptor from the DC IN jack on your camcorder.
Step 1 Preparing the power source
3
2
5
VCR
MEMORY/
NETWORK
CAMERA
OFF(CHG)
POWER