Filter
Top Products
Instruction
Manual
11
Snapshots:
The
Snapshots
screen allows you to view and save a screenshot of the
controlled computer in its current state. This screenshot will update periodically
(automatically). S aved image files are stored in .PNG format.
Logout:
Clicking on
Logout
will terminate your Web Interface section. To re-initiate the
Web Interface, you will be required to re-enter your username and password.
VNC:
To launch or disconnect a Virtual Network connection with the controlled computer,
click on
Connect
or
Disconnect
as appropriate
Network Config:
DHCP
: Automatic network configuration using DHCP is:
Enabled
/
Disabled
. This feature
applies only to the LAN port on the rear panel, and is enabled by default. When enabled,
the unit will automatically configure itself with an IP address when a DHCP server is
present. When disabled, the LAN port will use the values assigned to it on the IP
Addresses and Routing table below.
IP Addresses and Routing:
This table allows you to assign IP information for the LAN
and WAN ports separately. If you are using DHCP, the values for the LAN port will be
filled in automatically and any changes made will not affect the setup.
Domain Name Server:
This section allows you to specify DNS servers and the default
DNS domain suffix in use on the network. If DHCP is enabled, some of these values
may be supplied automatically.