StarTech.com VGANTSCPROGB TV Converter Box User Manual


 
Instruction Manual
4
Horizontal/Vertical Scaling
The VGA2NTSCPRO allows horizontal and vertical scaling so that an image can be
scaled to meet the visible part of your TV screen. If you are in Zoom mode, vertical
scaling is disabled.
1. Press the Menu button to call up the OSD menu.
2. Use the +/- buttons to scroll to the H/V Scaling icon. Press the Select button to view
the scaling settings.
3. A pair of small arrows will indicate whether you are in Vertical or Horizontal scale
mode. Use the Select button to toggle between Vertical and Horizontal mode.
4. The + button will spread your screen out towards the edges. The - button will
“tighten” or shrink the screen.
5. Once you are happy with your scaling settings, allow the converter to sit idle for a
few seconds. This will save the scaling settings and exit the OSD automatically.
Positioning
The positioning function allows you to move your TV image both vertically and horizontally.
1. Press the Menu button to call up the OSD menu.
2. Use the +/- buttons to scroll to the Positioning icon. Press the Select button to view
the positioning settings.
3. A pair of small arrows will indicate whether you are in Vertical or Horizontal positioning
mode. Use the Select button to toggle between Vertical and Horizontal mode.
4. Depending on your mode, the + button will shift the display either up or right. The -
button will shift the display either down or left.
5. Once you are happy with your position settings, allow the converter to sit idle for a
few seconds. This will save the position settings and exit the OSD automatically.
Brightness
There are four brightness levels supported by the VGA2NTSCPRO.
1. Press the Menu button to call up the OSD menu.
2. Use the +/- buttons to scroll to the Brightness icon. Press the Select button to view
the brightness settings.
3. Use the +/- buttons to set the desired brightness level.
4. Once you are happy with your brightness settings, allow the converter to sit idle for
a few seconds. This will save the brightness settings and exit the OSD automatically.