Filter
Top Products
CineCurve: Owner’s Manual 5
Professional mounting techniques should be used. Stewart Filmscreen
Corporation cannot be liable for substandard or faulty installations.
This section describes assembly and mounting of the CineCurve frame.
Refer to Figure 2.
1. Assemble the frame by fitting together the slip joints of the side
sections and center section. The sections are number matched.
Secure the sections using the supplied hex head bolts.
2. Attach the center wall mount bracket to the frame.
3. Mount the frame to the wall. If possible, attach to wall studs.
Alternately, use hollow wall anchors or molley bolts appropriate
for the weight of the screen and frame assembly.
4. Make sure the frame is level and plumb.
5. Ensure that after you attach the screen you can access the motor
and encoder cables for attachment to the BRIC controller.
6. When you are ready to connect the motor and encoder cables,
refer to the BRIC manual.
Figure 2: Unassembled frame; rear view
FRAME ASSEMBLY AND WALL MOUNT
Wall brackets
Slip joint