Filter
Top Products
CineCurve operation is controlled by a Stewart Filmscreen BRIC. Refer to
the BRIC manual for details. You can use either a hand-held remote control
or a wall mounted keypad to operate the masks.
General maintenance
The surface of your screen is delicate. Special attention to these instructions
should be followed when cleaning.
A draftsman-style brush may be used to lightly whisk away any
loose dirt or dust particles. (This type of brush is usually available
at office supply stores.) Stewart Filmscreen has an optional
screen cleaning kit that contains the proper type of brush.
Contact your dealer if you would like to obtain this cleaning kit.
For tougher spots, use a solution of mild detergent and water.
Rub lightly using a sponge. Blot with a damp sponge to absorb
excess water. Residual water marks will evaporate within a few
minutes.
Do not use any other cleaning materials on the screen. Contact the factory
if you have questions about removing difficult spots.
VeLux covering
Use a lint roller to remove particles from the VeLux material.
A brush can be used to comb (lift) the nap of the VeLux material
to help eliminate depression marks.
Replacement parts and service
No user-serviceable parts are contained within the unit. Contact your dealer
or the factory if you require part replacement or service.
CineCurve: Owner’s Manual 7
OPERA TING THE CINECURVE
SCREEN
CARE AND CLEANING
Caution
Keep objects and fingers out of the way of the masks when
they are in motion.
Caution
Do not use chemicals or liquid to clean the fabric.