Filter
Top Products
SB-WM46 Installation Instructions
6
ASSEMBLY and INSTALLATION
Install Arm Assembly/Wall Plate to Wall
Wood Stud Installation
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
IMPORTANT ! :
The
SB-WM46
mounts are designed to be
mounted to a 2" x 4" wood studs (16" on center) wall.
1. Level arm assembly/wall plate (A) and mark locations of
pilot holes. (See Figure 1)
2. Drill 1/4" (6.4mm) diameter pilot holes into wood supports.
(See Figure 1)
3. Install 3/8 X 2 1/2" lag screws (X) through flat washers (Y),
arm assembly/wall plate (A), into wood supports. (See
Figure 1)
Figure 1
Concrete Installation
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
IMPORTANT ! :
The
SB-WM46
mounts are designed to be
mounted to an 8" concrete wall.
1. Level wall plate and mark locations of pilot holes. (See
Figure 2)
2. Drill 3/8" (9.5mm) diameter holes into concrete. (See Figure
2)
3. Install anchors (S) into holes. (See Figure 2)
CAUTION: Do not overtighten lag screws (X)!
4. Install 3/8 x 2 1/2" lag screws (X) through flat washers (Y),
wall plate (A), into anchors (S). (See Figure 2)
Figure 2
(Y) x 4
(A)
3
1
x 4
2
x 4
(X) x 4
9/16" (14.3mm)
1/4" (6.4mm)
3
1
x 4
2
x 4
3/8" (9.5mm)
(S) x 4
(Y) x 4
(X) x 4
4
9/16" (14.3mm)