Filter
Top Products
- 11 -
User Manual
5.15 Motion Set
MOTION SET:
AREA SET:
Use [
Up] and [ Down] button to select the channel you want to modify and
press [
SEL] button to enter the sensitive area of each camera. The picture of the
selected channel is divided into 16(4*4) blocks, press [REW] to move left, press
[FWD] to move right, press[
Up] and [ Down] to move the cursor up and down,
press [
SEL] to set the highlighted block active or disabled.
When the block is transparent, it’s active or set to detect motion. When the
block is covered by a shadow, it is not active and motion will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
5.16 Video Mode
Select NTSC (North America) or PAL (Europe/Australia) video system.
SENSITIVITY:
Use [
Up] and [ Down] button to
highlight the channel you want to modify
and press [
SEL] to adjust sensitivity of
motion detection on each channel.
High (1----------9, OFF) Low
When “OFF”, the channel will not
detect motion or trigger motion recording.
MOTION RECORD TIME:
This number indicates how many
seconds the motion detection recording
lasts after the DVR has detected motion.
MOTION ALARM TIME:
This number indicates how many
seconds the buzzer/alarm inside the DVR
will sound after the DVR has detected
motion.
CONT: Continuous alarm until press any
key is pressed when motion detected.
OFF: No alar
m
MOTION SET
MOTION RECORD TIME: 10
MOTION ALARM TIME: OFF
MOTION SET
(UP，DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
(UP，DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT