Filter
Top Products
EN
AUX
SLEEP 0 MINUTE
BRIGHT
–
PPPPPPPPPPPPPPCCPPPPPPPPPPPPPP
+
SLEEP TIMER SETTING
The Sleep Timer function is used to turn off the
unit without pressing
[POWERy] after a desired
time.
1 Press [PICTURE / SLEEP] to
display the Sleep Timer menu.
2 Within 5 seconds, set your desired sleep time
using
[s / B].
• [B]...Increase by 30 min. (Up to 120 min.)
•
[s]...Decrease by 30 min.
NOTE:
•To cancel the Sleep Timer, use [CLEAR] or [s / B]
to set the time to "0".
3 To confirm the remainder time to shutdown,
press
[PICTURE / SLEEP].
PICTURE CONTROL
1 Press [PICTURE / SLEEP]
repeatedly until desired control
is displayed.
2 Use [s / B] to adjust to your desired level within
5 seconds.
• Even if any power failure occurs, the unit will
retain its memory for this feature.
COLOR
TINT
SHARPNESS
BRIGHT
CONTRAST
to pale
to purple
to soft
to decrease brightness
to decrease contrast
to brilliant
to green
to clear
to increase brightness
to increase contrast
VOLUME 20
C C C C C C C C C C C C C C C C
TV/VCRTV/VCR
9
T
V OPERATION AND SETTINGS
TV/VCR SECTION
WATCHING A TV PROGRAM
TV/VCRTV/VCR
OPERATING CONTROLS AND FUNCTIONS / TV OPERATION AND SETTINGS
TV/VCR SECTION
1 After antenna or cable connection is
completed, connect the power cord into
a standard AC outlet.
2 Press [POWER] to turn on the unit.
3 Use [CH.
K
/
L
] or the Number buttons to
select your desired channel number.
4 Use [VOL.
X
/
Y
] to adjust the volume.
Press
[MUTE] to instantly
mute the sound. Press it again
to restore the previous sound
level.
NOTE:
•Even if you turn off the unit in the DVD mode, the unit
will be in the TV/VCR mode when you turn it on again.
TO WATCH CABLE OR SATELLITE CHANNEL
If the unit is connected to a cable box or satellite
box, use
[CH. K / L] to select CH3 or CH4 accord-
ing to the output channel setting of the device and
select desired channel on that device.
TO WATCH EXTERNAL INPUT
When an external equipment is
connected to the front AUDIO/
VIDEO input jacks, press
[SELECT] or [CH. K / L] repeat-
edly until "AUX" appears on the
screen.
NOTE:
•If there is no signal input from the antenna terminal
and no operation for 15 minutes, the unit will turn
itself off automatically.
SLEEP TIMER / PICTURE CONTROL
You can set Sleep Timer and picture
adjustment with
[PICTURE / SLEEP].
• The menu changes as described below every time
you press [PICTURE / SLEEP].
Sleep Timer
BRIGHT
CONTRAST
COLOR
TINTSHARPNESS
To use the number buttons
•Single digit channels: (Ex. 02, 03, 04 and so on)
Press [0] first to select a single digit channel.
•Two digit channels: (Ex. 12, 38, 95 ...)
Press two digits directly.
•Three digit channels: (Ex. 115, 125 ...)
Press
[+100] first, then press the last two digits.
T1203UD(EN/SP).QX3 06.2.15 7:14 PM Page 9