Filter
Top Products
•
Cables used here are commercially available.
•
For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack
before moving the unit.
NOTE
- 10 - EN
PREPARATION FOR USE
ANTENNA/CABLE CONNECTION
IF YOU HAVE A JACK ON THE WALL
Connect the TV to the wall-mounted antenna jack
with on RF cable (commercially available).
IF YOU HAVE A WIRED CABLE
Connect the TV to the wired antenna cable.
WHEN USING CABLE BOX/SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown above.
Channel selection must be made with the converter
box or satellite box. This means that channels cannot
be changed using the remote control of this unit.
- ANTENNA/CABLE CONNECTION (WITH OR WITHOUT BOX)
[Rear of this unit]
DIGITA
L
A
UDIO O
UT
(C
O
AX
IA
L)
R
L
Y
P
b
P
r
R
L
VIDE
O
S-VIDEO
V
ID
E
O
2
C
P
M
P
O
N
E
N
T
A
U
D
I
O
A
U
D
IO
V
ID
E
O
1
A
NT
H
EA
D PHO
NE
ANT
IN
OUT
Cable TV
signal
or
Antenna
Incoming cable from home Antenna /
Cable Company (No Cable Box)
OR
Cable Box or
Satellite Box*
Incoming cable from Cable Company
or Satellite Antenna
•
Before plugging the antenna into the ANT. jack of the unit, check that the pin
is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into
the ANT. jack of the unit.
For CATV system installer:
•
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
NOTE
Bent pin
Cable
Plug
(Needs to be
straightened)
(Straight pin)
*Some cable TV systems use scrambled signals and
require a special converter to receive these channels.
Consult your local cable company.