Filter
Top Products
– 6 –
EN
Operating temperature : 5°C~40°C (41°F~104°F)
Converter output : VHF Channel 3 or 4.
Power requirement : AC120V, 60Hz DC13.2V (12V)
Power consumption : AC12W DC10W
Dimensions : W 11” (280mm)
H 3-5/8” (92mm)
D 9-13/16” (250mm)
Weight : 4.4 lbs. (2.0 Kg.) (approx.)
SERVICING
Should your VCP become inoperative, do not try to correct the
problem by yourself. There are no user-serviceable parts
inside. Turn off, unplug the power plug, and please call our
help line at
1-800-242-7158,
to locate an Authorized Service Center.
CABINET CLEANING
• Wipe the front panel and other exterior surfaces of the VCP
with a soft cloth immersed in lukewarm water and wrung dry.
• Never use a solvent or alcohol. Do not spray insecticide
liquid near the VCP. Such chemicals may cause damage and
discoloration to the exposed surfaces.
AUTO HEAD CLEANING
• Automatically cleans video heads as you insert or remove a
cassette, so you can see a clear picture.
• Playback picture may become blurred or interrupted while
the TV program reception is clear. Dirt accumulated on the
video heads after long periods of use, or the usage of rental
or worn tapes can cause this problem. If a streaky or snowy
picture appears during playback, the video heads in your
VCP may need to be cleaned.
1. Please visit your local Audio/Video store and purchase a
good quality VHS Video Head Cleaner.
2. If a Video Head Cleaner does not solve the problem, please
call our help line at 1-800-242-7158, to locate an Authorized
Service Center.
NOTES:
• Remember to read the instructions included with the video
head cleaner before use.
• Clean video heads only when problems occur.
• Designs and specifications are subject to change
without notice.
• If there is a discrepancy between languages, the
default language will be English.
If you have followed the instructions contained in this manual and have difficulty in operating your VCP, locate the
PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION column to remedy the problem.
PROBLEM CORRECTIVE ACTION
No power. • Make sure the power plug is connected to an AC outlet.
• Make sure the DC cord is connected to a 13.2 VOLT (12V) DC cigarette lighter socket.
Check the fuse on the DC cord.
• Make sure the power is turned on.
Playback picture is partially noisy
. • Adjust tracking control for a better picture by pressing [TRACKING o/p].
Cannot view a tape but the • Head cleaning may be necessary. Refer to “AUTO HEAD CLEANING” .
audio is OK
.
• Make sure the VCP is not in the Menu mode.
No or poor playback picture. • Fine tune your TV.
TV programs cannot be seen • Re-check the ANT. IN and ANT. OUT connections.
normally.
• Turn off the VCP.
No VCP operation from the • Make sure the power plug is connected to an AC outlet.
infrared Remote Control.
• Make sure the DC cord is connected to a 13.2 VOLT (12V) DC cigarette lighter socket.
Check the fuse on the DC cord.
• Check batteries in remote control.
Noise in picture on playback. • Head cleaning is necessary. Refer to “AUTO HEAD CLEANING”.
MAINTENANCE
SPECIFICATIONS
TROUBLESHOOTING GUIDE
TROUBLESHOOTING
GUIDE
MAINTENANCE
SPECIFICATIONS