Filter
Top Products
GENERAL SPECIFICATIONS
Television system: NTSC-M
TV Standard
Closed Caption
System: §15.119/FCC
Channel coverage
VHF: 2 – 13
UHF: 14 – 69
CATV: 2 – 13, A – W,
W+1 – W+84,
A-5 – A-1, 5A
Tuning System: 181 channels
frequency synthesized
tuning system
Channel access: Direct access keyboard,
programmable
scan and up/down
Terminals
Antenna input: VHF/UHF/CATV
75 ohm unbalanced
(F-type)
Video input: RCA connector x 1
(1 x Front)
Audio input: RCA connector x 1
(1 x Front)
Earphone: 1/8" monaural (3.5mm)
1 speaker
ELECTRICAL SPECIFICATIONS
Sound output: 1W, 8 ohm x 1
OTHER SPECIFICATIONS
Remote control: Digital encoded
infrared light system
Operating
temperature: 5°C to 40°C
(41°F – 104°F)
Power requirements: AC120V, 60Hz
Power consumption
(Maximum): 55W
Picture tube: 14"
Dimensions: H : 12-15/16" (329mm)
W: 14-1/8" (358mm)
D: 15-1/8" (384.5mm)
Weight: 23.1 lbs. (10.5kg)
•Designs and specifications are subject to
change without notice and without our
legal obligation.
•If there is a discrepancy between languages,
the default language will be English.
SPECIFICATIONS
OPTIONAL SETTINGS (Continued)
MAINTENANCETROUBLESHOOTING GUIDE
Sometimes a performance problem can be easily solved by checking seemingly apparent but often over-
looked possibilities. Before arranging for service, check these items. It could save your time and money.
QUICK SERVICE CHECK LIST
PROBLEM
POSSIBLE REMEDY
Try a new channel, if OK, then possible station trouble.
Is TV plugged in?
Power at outlet?
Is TV’s power on?
Is antenna or cable connected to terminal on the back of the set?
If outside antenna is being used, check for broken wire or loose connection.
Check for local interference.
Turn off the TV and then turn it on after about a minute.
Adjust COLOR control.
Adjust CONTRAST & BRIGHT control.
Check batteries in remote control.
Move the TV away from the nearby appliances which generate a magnetic field.
Turn off using [POWER], then turn it on again 30 minutes later or so.
Check if there is an obstacle between the sensor and the remote control.
Test the signal output.* If OK, then possible remote sensor trouble.
Remote Control Doesn’t Work
Bars On Screen
Picture Distorted
Picture Rolls Vertically
No Color
Poor Reception on Some Channels
Weak Picture
Lines or Streaks in Picture
Ghosts in Picture
Picture Blurred
Sound OK, Picture Poor
Picture OK, Sound Poor
No Picture or Sound
Different color marks on screen
*Additional Remote Test
Tune an AM radio to a band with no broadcasting. Press a button on the remote control toward the radio. Sound will be
fluttering when you press any key and the radio receives the signal. This means the remote control unit is working.
Closed Caption Problem Possible Remedy
Misspelled captions are shown.
Text is not shown in its entirety
or there is a delay of what is being said.
Captions are scrambled with white boxes
on the TV screen.
No captions are displayed in a program
which must contain closed caption.
No captions are displayed when playing a
prerecorded videotape with closed caption.
The TV screen shows a black box.
Spelling errors may pass through uncorrected by the closed caption-
ing production company in a live broadcast.
Captions that are delayed a few seconds behind the actual dialogue
are common for live broadcasts. Most captioning production compa-
nies can display a dialogue to a maximum of 220 words per minute.
If a dialogue exceeds that rate, selective editing is used to insure that
the captions remain up-to-date with the current TV screen dialogue.
Interference caused by building, power lines, thunderstorms, etc.
may cause scrambled or incomplete captions to appear.
Broadcasters may use a time compression process to the actual pro-
gram so that additional advertising time can be given. In this case,
captions will be lost since the decoder cannot read the compressed
information.
The videotape may be either an illegal copy or the tape duplicating
company may accidentally have left out the captioning signals dur-
ing the copying process.
You are in TEXT mode. Select CAPTION [C1], [C2] or [OFF].
CABINET CLEANING
●
Wipe the front panel and other exterior sur-
faces of the TV with a soft cloth immersed
in lukewarm water and wrung dry.
●
Never use a solvent or alcohol. Do not spray
insecticide liquid near the TV. Such chemi-
cals may cause damage and discoloration to
the exposed surfaces.
PICTURE TUBE CLEANING
Wipe the picture tube of the TV with a soft
cloth. Before cleaning the picture tube, discon-
nect the power cord.
SUPPLIED ACCESSORIES
●
Owner’s Manual
(1EMN21761)
●
Remote control unit
(NE121UE)
●
Batteries
(“AA” x 2)
1
1
6
6
MENU
To exit the menu
Notes (for TV RATING and MPAA
RATING):
●
You cannot access the setup menu when the
“PROTECTED PROGRAM by ...” message
appears. Move to an unblocked channel
before you press [MENU].
●
When you select a rating and set it to
[BLOCK], the higher ratings will be
blocked automatically. The lower ratings
will be available for viewing.
●
When you set “X” or “TV-MA” to [VIEW],
all ratings turn to [VIEW] automatically.
V-CHIP SET UP
MENU
To exit the menu
4
4
Select a rating
CH
CH
TV-Y
[VIEW]
TV-Y7 (
)
[VIEW]
TV-G
[VIEW]
TV-PG
( )
[VIEW]
TV-14
( )
[VIEW]
TV-MA (
)
[VIEW]
<Selection> <Rating Category Explanations>
• TV-Y : Appropriate for all children
• TV-Y7 : Appropriate for children seven
and older
• TV-G : General Audience
• TV-PG : Parental Guidance suggested
• TV-14 :
Unsuitable for children under 14
• TV-MA : Mature audience only
5-1
5-1
* Rating with no sub categories
Set to [BLOCK] or [VIEW]
VOL
TV-Y
[VIEW]
TV-Y7 (
)
[VIEW]
TV-G
[BLOCK]
TV-PG
(DLSV)
[BLOCK]
TV-14
(DLSV)
[BLOCK]
TV-MA (DLSV)
[BLOCK]
* Rating with sub categories
VOL
TV-PG
[BLOCK]
D
[BLOCK]
L
[BLOCK]
S
[BLOCK]
V
[BLOCK]
TV-Y
[VIEW]
TV-Y7 (
)
[VIEW]
TV-G
[VIEW]
TV-PG
( )
[VIEW]
TV-14
( )
[VIEW]
TV-MA (
)
[VIEW]
Sub categories
CH
CH
Select a rating
VOL
Set to [BLOCK] or [VIEW]
TV-PG
[BLOCK]
D
[VIEW]
L
[BLOCK]
S
[BLOCK]
V
[BLOCK]
This enables parents to prevent their children
from watching inappropriate material on TV.
● The limitation is not available for news,
sports programs, unedited movies on premi-
um cable channels and Emergency
Broadcast System signals.
●
When you try to access to a program which is
blocked, “PROTECTED PROGRAM by ...”
message appears on the TV screen.
● Programming may be rated by the Motion
Picture Association of America (MPAA) or
according to the Television Parental
Guidelines. In order to block any inappro-
priate programming, set your limits in both
MPAA RATING and TV RATING.
MENU
CH
CH
PICTURE
CHANNEL SET
[ENG] / ESP / FRA
V-CHIP SET UP
CAPTION [OFF]
VOL
Select “V-CHIP SET UP”
<Selection> <Rating Category Explanations>
• TV-Y7
FV: Fantasy Violence
• TV-PG / TV-14 / TV-MA :
D: Suggestive Dialog
(TV-PG, TV-14 only)
L: Coarse Language
S: Sexual Situation
V: Violence
6
6
[MPAA RATING SET UP]
2 times
CH
CH
VOL
TV RATING
MPAA RATING
CHANGE CODE
Press [CH K / L] to select “TV RATING”,
“MPAA RATING” or “CHANGE CODE”,
then press [VOL K].
3
3
5-2
5-2
<Selection> <Rating Category Explanations>
• G : General Audience
• PG : Parental Guidance suggested
• PG-13 : Unsuitable for children under
13
• R : Restricted; under 17 requires
accompanying parent or adult
guardian
• NC-17 : No one under 17 admitted
• X : Mature audience only
4
4
CH
CH
G [VIEW]
PG
[VIEW]
PG-13
[VIEW]
R
[VIEW]
NC-17
[VIEW]
X
[VIEW]
Select a rating
123
456
789
0 +100
ACCESS CODE
_ _ _ _
Enter 4-digit access code. If you have
not set up your personal access code,
enter 0000 (default access code).
2
2
A
B
C
[TV RATING SET UP]
A
B
repeatedly
5
5
VOL
Set to [BLOCK] or [VIEW]
G [VIEW]
PG
[VIEW]
PG-13
[VIEW]
R
[BLOCK]
NC-17
[BLOCK]
X
[BLOCK]
[CHANGING THE ACCESS CODE]
C
Notes:
●
Make sure you enter exactly the same new
code in the “CONFIRM CODE” space as
one in the “NEW CODE” space. If they are
different, the “NEW CODE” space is
cleared for redoing.
●
Your personal access code will be erased
and will return to the default (0000) when a
power failure occurs or when you turn off
the power using a wall switch. If you have
forgotten the code, unplug the power cord
for 10 seconds to restore the access code to
0000.
4
4
Enter 4-digit code.
NEW CODE
CONFIRM CODE
[[[[
_ _ _ _
123
456
789
0 +100
5
5
To exit the menu
MENU