Filter
Top Products
Using the Presenter as a SD memory card reader
1. Position the Power switch to “Card Reader / Off” position.
2. Connect the presenter with the computer using the USB data
transfer cable provided. Please make sure the mini USB
connector (Type-B) is connected to the presenter’s USB port and
the large USB connector (Type-A) is connected to the computer’s
USB port.
3. Insert the SD memory card into the presenter’s card slot until it is
fully inserted.
The computer will detect the memory card and once detected, the
memory card is ready for access.
USB data transfer cable
(Type-A) USB tip
(Type-B) USB tip
2. Once the computer has recognised the device. Press the
connection button on the receiver.
3. After the connection button is pressed on the receiver, press the
connection button on the back side of the presenter.
The devices are paired and ready to use.
To Reconnect the Device and the Receiver
Position the Power Switch to “Presenter” mode to turn on the presenter.
This presenter is a plug and play device and should work once the USB
receiver is connected to and recognised by the computer. If the device is
not working or you have recently replaced the batteries, you can try to
reset the ID code between the receiver and the remote. To do this, do the
following:
Note: Please remember to turn the power off (to Card Reader / Off mode) before
connecting the data cable to the PC for card reader function. For best
performance please use SD card with minimum of 128MB storage space. Try to
avoid using mini SD card with adapter. Avoid having a large amount of data
stored in the SD card. It will delay the loading time for the presenter.
Targus Voice Recording presenter with Laser Pointer
1.
6