Filter
Top Products
8
Getting Started
SD Cards
Precautions for handling SD and SDHC
cards
Note:
• The disc operation display icon appears blinking and
“READING” is displayed on the display window when
the SD card is being accessed (such as during dubbing,
playback, or formatting). When access to the SD card is in
progress, do not remove the card or the power plug. Doing
so may cause the SD card to become unusable.
If the SD card is not usable, reformat the card. If the problem
persists even after reformatting, use a new SD card.
• Do not use or store the card at a place that is subject to
static or electrical noise.
• Inserting the SD card incorrectly may cause this unit or the
card to malfunction.
• Our company will not be liable for any damage or loss of the
stored data due to accidents. (Be sure to back up the data.)
• Use the card according to the prescribed conditions. Do not
use it at the following locations.
• Places that are exposed to direct sunlight
• Places near heat-generating equipment
• Inside a car that is under the sun with the windows tightly
shut
• Places that are subject to high humidity and corrosion
• Do not bend or drop the card, or subject it to strong impact
or vibration.
• Do not expose the card to water.
• Do not place near devices that emit strong magnetic or
radio waves.
• Do not touch the metal part of the card.
Memo:
To dispose a card after erasing all data inside, it is
recommended that this be done using a commercially
available data deletion software, or by destroying the card
physically, such as with a hammer. Formatting or deletion
of data using this unit only changes the le administration
information, and does not erase the data completely.
BD video data
You can erase BD Video data from the SD card as follows.
1
Insert the SD card which has BD video data
stored on it, into the [SD SLOT]
Memo:
• The BD video data cannot be erased if the SD card is write-
protected. In this case, turn off the write-protect lock before
inserting the SD card.
2
Press the [MEDIA MANAGE] button on the remote
control unit
3
Select “BD-VIDEO DATA ERASE” from “SD
CARD”
• The conrmation screen for erasing the BD video data is
displayed.
4
Select “ERASE”, and press the [OK] button
• The BD video data will be erased.
Hard Disk Drive (HDD)
Hard disk drive (HDD)
The HDD rotates at a high speed whenever the power is
turned "On".
Pay particular attention to the following precautions when
using this unit.
Warning
• Do not subject it to vibration or strong impact
Subjecting this unit to excessive impact may result in loss
of recorded data and even damage of the HDD.
• Do not remove the power plug when this unit is running
Shutting down the power when the HDD is running may
result in data loss and even damage of the HDD. Make sure
that the power plug is removed only after turning off the
power.
(Wait for the "GOODBYE" message on the display window
to disappear rst)