Filter
Top Products
4
PLEASE READ BEFORE USE
Product Installation Notice
What happens when first time connected?
When power is first applied, you product will introduce a step-by-step setup process on screen. At the
same time, the internal hard-drive will begin the checking process (takes about 10 minutes). Whilst
this process is taking place, the rewind, record and pause television functions cannot be used. In
addition, the USB ports may not available for use until approximately 2 minutes after the checking
process has completed.
Is Digital TV reception available in your home?
Generally speaking; if this receiver was on display (demonstration) by your local retailer and you live
within the same area/town/city, then it should work within your home.
If you experience break-up of picture or poor performance, it is recommended that you contact your
professional television antenna installer first. Many users assume that if the analogue television signal
is good then the digital television signal will also be good. This is rarely the case.
Your professional antenna installer will need to check your signal quality (not necessarily the signal
strength) for digital reception. The antenna installer may advise you to upgrade your television
antenna to a new digital ready antenna, and install new cabling such as RG6 quad shield cable.
For more information on digital television installations, visit the Digital Broadcast Australia website
found at http://www.dba.org.au
.
I don’t seem to have Digital TV reception in my home, what shall I do?
Digital Television is still considered relatively new to Australia and it will take time for it to be available
everywhere around Australia. If Digital Television reception is not available to you, neatly place
together all packaging and supplied cables back into the box. Have your receipt (proof of purchase
)
ready and contact your place of purchase for further details on what you should do.
Going into Standby mode
When you enter the standby mode; around 1 minute later, your set-top box will partially turn back on
by itself to do some additional network and hard-disk checking. This takes around 20 seconds and
the front display may go blank. This is normal. The set-top box will automatically go back to standby
mode when completed.