Technika LCD 32-244 Flat Panel Television User Manual


 
26
General Information
OPERATING THE TV WITH A UNIVERSAL
OR SKY (BSKYB) REMOTE CONTROL
Using a Universal Remote Control.
You may wish to use a Universal Remote control to operate your Television. In order to do so, you
will need to enter the ‘code’ below into your universal remote control, to do this, please follow the
instructions included with the Universal remote control. Please note that if your remote control does not
accept the code, this is because the software/fi rmware installed on the remote control is too old. Please
contact the manufacturer of the Universal Remote control for assistance.
Universal Remote Code - 2106 (TV functions) 2302 (DVD Functions - where included on the TV)
Using a Sky / Sky+ / Sky HD Remote Control
If you wish to use your Sky remote control to operate the your Television, you need to programme a 4
digit code into your Sky, Sky+ or Sky HD remote control.
Please note that the code below will only be accepted if the Sky remote control is a Revision 9 (launched
Autumn 2010) or later.
To fi nd out which version of Sky remote you have, remove the battery cover, you should see a sticker
showing the ‘Rev’ number.
If your Sky remote is Rev 8 or earlier, you will need to purchase a new Sky Remote control in order to
operate the TV’s functions. At the point of manufacturer of this TV, the latest Revision 9 remote controls
are only available to purchase directly from Sky, alternatively, you can purchase our versions from the
helpline / website.
If your Sky remote control is a Revision 9 or later, please follow the instructions below.
1) Switch on the TV set
2) Press the ‘TV’ button on the Sky Remote
3) Hold down the ‘select’ and ‘red’ buttons for 2-3 seconds until the LED blinks twice
4) Press the ‘TV’ button on the Sky Remote again
5) Enter the 4 digit code (see below)
6) The LED should blink twice, if not recheck the 4 digit code used and go back to step 1
7) Press the ‘standby’ button on the Sky Remote (The TV should go to standby)
8) Press ‘select’ to store this setting
Sky / Sky+ / Sky HD Remote code - 2134 (Revision 9 or later only)
The very latest versions of remote controls to operate your Sky
/ Sky+ / Sky HD in addition to operating the functions of the
Television can be purchased from the helpline or website.
www.skymediauk.co.uk
Our versions (from One for All) are slightly smaller than the
regular Sky remotes and operate your Sky box the same way
your current Sky remote does, in addition, our versions operate
the functions of your television as they include the very latest
software/fi rmware.
Please note that as we have to install the necessary software /
fi rmware onto the remote control prior to shipping, you must
provide us with your TV model number in order that we can
do this.
Sky Sky+/Sky HD
Manual - Technika - LCD32-244.indd Sec1:26Manual - Technika - LCD32-244.indd Sec1:26 9/6/2010 4:52:14 PM9/6/2010 4:52:14 PM