Filter
Top Products
M205 User's Manual
Page 2
M205 User’s Manual
nn nn nn FCC NOTICE
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interface to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television equipment reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Move the equipment away from the receiver
Plug the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/television technician for additional suggestions
Only equipment certified to comply with Class B should be attached to this equipment, and must have
shielded interface cables.
The FCC requires the user to be notified that any change or modifications to the equipment by the user
not expressly approved by the grantee or manufacturer could void the user’s authority to operate such
equipment.
Each M205 is equipped with an FCC compliance label which shows only the FCC Identification
number: FCC ID: KHAM205.
This device complies with Part 15 of the FCC rule. Operation is subjected to the following two
conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause undesired
operation.
nn nn nn DISCLAIMER
The manufacturer (MFR) reserves the right to make changes to this document and the products which it
describes without notice. The MFR shall not be liable for technical or editorial errors or omissions made
herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of
this material.
The MFR makes no representation that the interconnection of products in the manner described herein
will not infringe on existing or future patent rights, nor do the descriptions contained herein imply the
granting of license to make, use or sell equipment constructed in accordance with this description.
Features and specifications are subject to change without notice. Trademarks and/or registered
trademarks are the properties of their respective owners: