Software Control
www.ti.com
• FIFO: allows the configuration of the FIFO and FIFO sync sources.
• LVDS delay: provides internal delay of either the LVDS DATA or LVDS DATACLK to help meet the
input setup/hold time.
• Data Routing: provides flexible routing of the A, B, C, and D sample input data to the appropriate
digital path.
Note: the DAC3482 does not support this mode
• SIF Control: provides control of the Serial Interface (3-wires or 4-wires) and Serial Interface Sync (SIF
Sync).
• Input Format: provides control of the input data format (i.e., 2’s complement or offset binary).
• Parity: provides configuration of the parity input.
• PLL Settings: provides configuration of the on-chip PLL circuitry.
• Temperature Sensor: provides temperature monitoring of DAC3484/2 die temperature.
2.2.1.1 LVDS Delay Settings
The TSW3100 pattern generator sends out LVDS DATA and DATACLK as edge-aligned signal. The
following options can be implemented to meet the minimum setup and hold time of DAC348x data
latching:
• Set the on-chip LVDS DATACLOCK delay. Typical setting of 160ps or more will help meet the timing
requirement for most of the TSW3100 + DAC348x EVM setup. This LVDS DATACLOCK delay does
not account for additional PCB trace-to-trace delay variation, only the internal DATACLK delay.
• Modify the external LVDS DATACLK PCB trace delay: Additional trace length on the bottom side of the
PCB can be added to the LVDS DATACLK PCB trace length. Set SJP9, SJP10, SJP11, and SJP12 to
2-3 position for approximately 220ps of trace delay.
2.2.1.2 PLL Settings
Figure 3. PLL Configuration
Follow the steps below to configure the PLL.
• Enable PLL
• Uncheck PLL reset and PLL sleep
• Set M and N ratio such that F
DAC
= (M)/(N)×Fref
• Set the prescaler such that the F
DAC
×prescaler is within 3.3GHz and 4.0GHz
• Set VCO Bias Tune to “1”
• Charge Pump setting
– If stability (P×M) is less than 120, then set to “Single
– If stability (P×M) is greater than 120, then set to “Double” or install external loop filter
• Adjust the Freq. Tune (coarse tune) accordingly.
4
DAC3484/DAC3482 EVM SLAU336–March 2011
Submit Documentation Feedback
© 2011, Texas Instruments Incorporated