Open as PDF
(Fig. 1)(Fig. 1)
Belgium and Luxembourg
Select your country and press OK
03 STATIONS FOUND
Searching for TV stations.
Please wait. To cancel press EXIT.
Installing your television for the first time
Installingyour television f or the firsttime
First plug the television into amains power outlet and to the external aerial ora cable network, then switch onusing
the ON/OFF switch
located on the front or the side of your set.
When you switch on your television for thefirst time, the languageselection menu* is displayed (Fig. 1). If this does
not happen,set thetelevision tostandby thenpress andhold the
key on thetelevision untilthis menu appears.
Installation Instructions (start)
1. Use the Up/Down keys to select the
language in which you wish the menus to be
2. Then validate using
3. A list of countries* is now displayed (Fig. 2).
Select the country in which you live, or the
country from which you wish to receive the
broadcasts if you live in a border area.
4. Then validate using
5. A welcome message is displayed.
6. Run the automatic installation sequence
7. A message appears to inform you that
automatic installation has started (Fig. 3).
Wait for a few minutes.
A new message will inform you when
automatic installation is completed.
8. If you wish to check or modify the channel
and see the
Programme organisation chapter.
If you do not wish to modify the channel
organisation, you can exit the menu by
then watch the channel of
your choice. Choose the desired channel
using the number keys (1, 2, 3, ...) and the
If you have a decoder, see the Manual
Your television will only search for channels
corresponding to the country you have
selected. See the Manual channel
programming chapter to install any channels
For cable networks, read the Automatic
channel installation chapter to install any
channels not found.
*The list of languages and countries may vary
from one model to another.
Installation Instructions (end)