Technicolor - Thomson 42 WM 03 L Flat Panel Television User Manual


 
30 Plasma Monitor
Miscellaneous
Programming your remote control
Programming your remote control
To control other devices
You can program your remote control for it to control other devices. Before following the adjustment procedure below, look for the 3-
digit code number(s) corresponding to the make of the device(s) to be controlled in the list of codes enclosed separately, then insert
them in the table below.
Apparatus Codes
Amplifier
VCR
Programming Volume and Mute keys
Your remote control has been factory-set to control the
Volume +/-
and
Mute
( ) functions on the THOMSON DPL 2000 amplifier.
If you wish to control the
Volume +/-
and
Mute
( ) functions on your set, you
must change the factory-settings as follows:
1. Slide the key to the
plasma
position.
2. While maintaining the key pressed, key in the code "001".
3. Release the
menu
button.
Volume +/-
and
Mute
( ) keys are now configured to control the set. To control the amplifier, place the key on the
hi-fi
position.
To return to factory-settings, repeat the above procedure, keying in "000".
1. Position the switch on the device that you want to control.
2. Keep the key down and enter the 3-digit code.
3. Release the
menu key.
• Try to control the device by turning it off, then on with the key
(the above key being on the corresponding position).
• If this does not work, repeat the process from step 2 with another 3-digit code.
Some devices cannot be controlled by the universal remote control supplied.
• Test the functions that you can control by using this remote control.
• According to the devices and the date they were put on the market, all the functions may not be available.
If you have programmed you remote control to control other makes than Thomson, it may be necessary to
reprogram it when you change the batteries.
Satellite receiver
DVD or LD unit
Amplifier Monitor
Code Code
000 001