Filter
Top Products
ENGLISH - 19 -
If the selected subcode page is not displayed in a
short time, press
button. TV programme will be
displayed on the screen.
Teletext page number will be displayed on the upper
left corner of the screen when the selected page is
found.
Press button to display the selected Teletext
page.
10 To exit Teletext
Press button. The screen will switch to TV
mode.
11) To Display the Time
While watching a TV programme with Teletext trans-
mission press button. The current time informa-
tion, captured from Teletext will be displayed at the
upper right of the screen.
If the programme being watched does not have Tele-
text transmission, no iformation will be displayed.
12) Fastext
Your CTV supports the 7 page Teletext system. When
the page number of any of the 7 pages in memory is
entered, the system will not search for the requested
page; instead it will display the page automatically.
Press button to move the Teletext screen for-
ward one page at a time.
Press button to move the Teletext screen back-
ward one page at a time.
For Fastext
The subject-heading for the information may have a
particular colour.
Press an appropriate RED, GREEN, YELLOW or
BLUE button in order to reach the relevant page
quickly.
Connect Peripheral Equipment
There is a wide range of audio and video equipment
that can be connected to your TV.
The following connection diagrams show you where
the different equipment should be connected at the
back or the front side of the TV.
1) Via the Euroconnector
Your TV set has two Euroconnector sockets. If you
want to connect peripherals (e.g. video, decoder, etc.)
which have Euroconnectors to your TV, use optional
EXT.1 or EXT.2 inputs.
If an external device is connected via EXT.1 Eurocon-
nector socket TV is switched to AV mode automatical-
ly. If the signal is RGB then the RGB OSD indicator is
displayed on the screen.
2) YCbCr Mode
This mode is only used for the equipment which have
YCbCr signal at their output. You can watch only YCb-
Cr signal at this mode. RGB, Y/C or CVBS signals
can not be watched.
3) Via Ant Input
If you want to connect to your TV, peripherals like vid-
eo recorders or decoders, but the device you want to
connect does not have Euroconnector, you should
connect it to the ANT input of your TV set.
If the VCR is connected via antenna input it is sug-
gested to use the Programme 0.
4) Decoder
Cable TV offers you a wide choice of programs. Most
of them are free, others are to be paid for by the view-
er. This means that you will need to subscribe to the
broadcasting organisation whose programmes you
wish to receive. This organisation will supply you a
corresponding decoder unit to allow the programmes
to be unscrambled.
For further information ask your dealer. See also the
booklet supplied with your decoder.
a) Connect a decoder with an aerial socket
to the TV
Connect the aerial cable.
b) Connect a decoder without an aerial
socket to the TV
Connect the decoder to your TV with a eurocable to
EXT.1. When your decoder has a Euroconnector you
can obtain better picture quality if you connect a
eurocable to EXTERNAL.
5) TV and Video Recorder
Connect the aerial cables.
Better picture quality can be obtained if you also con-
nect a eurocable to EXTERNAL sockets.
EU2845ST&2845W-MAV-1541-ENG-STEREO-AK45.p65 09.09.2003, 10:5419