Filter
Top Products
11
Appendix
Using the TV’s
Features
Setting up
your TV
Using the
Remote Control
Connecting
your TV
Welcome to
Toshiba
Important
Safeguards
Using the remote control
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two “AAA” size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
POWER turns the TV on and off
CHANNEL NUMBERS allow direct access to channels (page 13)
RECALL displays status information on-screen (page 21)
SLEEP programs the TV to turn off at a set time (page 22)
MUTE turns off the sound (page 23)
CH + / – cycles through programmed channels (page 13)
VOLUME + / – adjusts the volume level
MENU/ENTER allows access to programming menus, and sets
programmed menu information (page 12)
EXIT exits programming menus (page 12)
CAP/TEXT turns closed captions or text on and off (page 22)
1/2 selects closed caption/text channel 1 or 2 (page 22)
RESET returns settings to preset factory formats (pages 21 and 23)
CH RTN (Channel Return) returns to the last viewed channel (page
14)
MTS switches among STEREO, SAP, and MONO sound (page 23)
TV/VIDEO selects the video input source (page 21)
FAV
▲/ ▼
(Favorite Channels) cycle through favorite channels
(page 14)
Learning about the remote control
Using the
Remote Control
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated
disposal area.
• Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable laws
and regulations.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace batteries with new ones.
• When necessary to replace batteries in the
remote control, always replace both
batteries with new ones. Never mix battery
types or use new and used batteries in
combination.
• Always remove batteries from remote
control if they are dead or if the remote
control is not to be used for an extended
period of time. This will prevent battery acid
from leaking into the battery compartment.
3U50101A(E)_P07-13 3/31/05, 6:18 PM11