Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
15
53AX61(E)
Verifying the device code (990)
Use this feature to verify the device codes currently programmed in
the remote control. The number of blinks after pressing the 1, 2, 3,
and 4 buttons is the 4-digit code set up for that mode.
For example, to verify the device code for the VCR mode:
1. Repeatedly press MODE until the VCR mode is selected.
2. While holding down RECALL, press 9, 9, 0.
3. Press 1 ➝ 0 blinks.
4. Press 2 ➝ 3 blinks.
5. Press 3 ➝ 8 blinks.
6. Press 4 ➝ 5 blinks.
This verifies that the device code of the VCR mode is “0385.”
Using the Volume Lock feature (993)
For the TV, CABLE/SAT, VCR, and DVD modes, the volume
controls (VOL yz and MUTE) can be programmed or locked to the
selected device mode. This feature does not apply to the AUDIO1
and AUDIO2 modes.
For example, to lock the volume controls to the CABLE/SAT mode:
1. Repeatedly press MODE until the CABLE/SAT mode is selected.
2. While holding down RECALL, press 9, 9, 3.
3. Press VOL y. When locked, the mode indicator will blink two
times.
The following table describes in more detail the Volume Lock
implementation.
Volume
TV CBL/SAT VCR DVD AUD1 AUD2
locked to:
TV (default)
TV TV TV TV AUD1 AUD2
CBL/SAT CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2
VCR VCR VCR VCR VCR AUD1 AUD2
DVD DVD DVD DVD DVD AUD1 AUD2
AUD1 AUD1 AUD1 AUD1 AUD1 AUD1 AUD1
AUD2 AUD2 AUD2 AUD2 AUD2 AUD2 AUD2
To reset the volume controls to the original device code:
1. While holding down RECALL, press 9, 9, 3.
2. Press VOL z. When unlocked, the mode indicator will blink
four times.
Operational feature reset (980)
This feature clears all setup features not related to “Device code set
up,” and resets the Volume Lock to “TV.”
To reset the features:
While holding down RECALL, press 9, 8, 0.
When reset, the mode indicator will blink two times, and then
pause and blink two more times.
Number
MODE
RECALL
VOL yz