Filter
Top Products
87
Chapter 8: Using the TV’s features
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 56/62/72MX195
Adjusting the picture (continued)
Using MPEG noise reduction
The MPEG noise reduction feature allows you to reduce visible
interference caused by MPEG compression. Choices for MPEG
noise reduction are High, Medium, Low and Off. Off is
automatically selected when this feature is disabled (“grayed
out”). This feature is not available in the PC input mode.
To select MPEG Noise Reduction preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. In the MPEG Noise Reduction field, select your desired
setting.
Done
Advanced Picture Settings ANT 1
Dynamic Contrast On
MPEG Noise Reduction
CableClear Auto
Color Temperature Cool
Lamp Mode Low Power
Reset
Low
Color Management
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Using dynamic contrast
When dynamic contrast is set to “On,” the TV will detect
changes in the picture quality that affect the appearance of your
contrast settings and automatically adjust the video.When
dynamic contrast is set to “Off,” the settings selected in the
Contrast field in Picture Settings will be used.
To select dynamic contrast preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. In the Dynamic Contrast field, select either On or Off.
Done
Advanced Picture Settings ANT 1
Dynamic Contrast On
MPEG Noise Reduction
CableClear Auto
Color Temperature Cool
Lamp Mode Low Power
Reset
Low
Color Management
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then change the dynamic contrast to
“On,” the picture mode automatically changes to Preference in
the Picture Settings menu.
#01E_084-093_566272MX195 05.7.11, 9:32 PM87
Black
Downloaded from www.Manualslib.com manuals search engine