Filter
Top Products
31
Playback
Recording
Editing
Others
Introduction
Function setup
Entering characters
The cursor may be followed by unwanted characters.
You can erase them if necessary by either of the
following measures:
Erasing characters
• Erasing all the characters on the writing board
Select “Clear All” by pressing
/ / / buttons, then
press SELECT/ENTER button.
Alternatively, press CLEAR button.
• Erasing one character before the cursor
Select “BkSp” by pressing
/ / / buttons, then
press SELECT/ENTER button.
(1) Press
button to select an input mode.
(2) Press
/ / / buttons to select a character, then
press SELECT/ENTER button.
The selected character is input on the cursor.
(3) Repeat steps (1) and (2) to enter characters.
(4) When finished, press
button to save the
characters.
The characters you entered appears.
Notes
• You can enter up to 64 characters.
• When unnecessary information appears, or when you want
to alter the input character, press CLEAR button to erase
all, or select “BkSp” or “Delete” to erase an unnecessary
character.