Filter
Top Products
18
HLC56 (E/F) Web 213:276
Chapter 3: Using the remote control
Using the remote control to operate
your other devices
If you have a non-Toshiba device or a Toshiba device that the
remote control is not preprogrammed to operate, you must first
program the remote control to recognize the device (if you
have not already done so) (- pages 20–22).
To use your remote control to operate a:
• Cable converter box or satellite receiver, set the MODE
SELECT Switch to CABLE/SAT.
• DVD player or HTIB, set the MODE SELECT Switch to
DVD.
• VCR, set the MODE SELECT Switch to VCR.
Note: Even after the remote control is programmed, it may not
operate certain features on your other device. If this happens
and you wish to use those features, you will need to use the
device’s original remote control.
1 POWER Turns the selected device on and off.
2 Channel Numbers (0-9) Press to directly access
channels (as opposed to < ,).
3 +10 Press to directly access DVD chapters higher than 10.
4 CH Bb
B selects the next higher channel;
b selects the next lower channel (for channels
programmed into memory only).
5 INFO Displays the monitor’s status information on-
screen.
6 BbC c Press to navigate DVD menus (may not work on
some DVD players).
7 ENTER Required by some satellite receivers and DVD
players.
8 DVD CLEAR Press to reset the title and chapter number.
9 PLAY Begins playback of a tape or DVD.
10 PAUSE Press during play or record mode to pause the
picture; press again to restart.
11 STOP Stops the tape or DVD.
12 SKIP z Skips forward to locate later DVD chapters.
13 FF Fast-forwards the tape or DVD. (Press during play
mode to view the picture moving rapidly forward.)
14 SKIP Z Skips back to beginning of current DVD chapter
or locates previous chapters.
15 REW Rewinds/reverses the tape or DVD. (Press during
play mode to view the picture moving rapidly backward.)
16 TV/VCR To view one program while recording another,
press to select TV mode.
17 REC Starts tape recording.
18 TOP MENU Accesses a DVD’s top menu.
19 SET UP Accesses a DVD’s setup menu.
20 MODE SELECT Switch Set to “TV” to control the
monitor; “CABLE/SAT” to control a cable converter box
or satellite receiver; “DVD” to control a DVD player or
HTIB; “VCR” to control a VCR.
Point the remote control
directly at the device.
263237HLC56_EN.book Page 18 Monday, June 5, 2006 3:46 PM