Filter
Top Products
Taper nut driver
70909228
SERVICING FIXTURES AND TOOLS
Back tension cassette gauge
70909103
Torque cassette gauge
(KT-300NR)
70909199
Adapter
Dial Torque Gauge
(10~90gf•cm)
(60~600gf•cm)
JG154 Cable
VTR cleaning kit VTR lubrication kit Grease JG002B
JG002E
JG002F
JG153 X Value Adjustment
Screwdriver
JG022 Master Plane JG024A Reel Disk Height
Adjustment Jig
Part No. Remarks
JG002B VSR Torque, Brake Torque (S Reel/T Reel Ass'y)
JG002E Brake Torque (T Reel Ass'y)
JG002F
VSR Torque, Brake Torque (S Reel)
JG153
X Value Adjustment
JG022/JG024A
Reel Disk Height Adjustment
Used to connect the test point of SERVICE and GROUNDJG154
Alignment Tape
ST-N5
ST-NF
Tentelometer
PREPARATION FOR SERVICING
How to use the Servicing Fixture
1.
2.
3.
4.
Unplug the connector CP353, CP354, then remove the TV/VCR Block from the set.
Remove the Operation PCB from the set, then connect it with the Syscon PCB.
If necessary, connect CP353 (Front A/V Jack Input Terminal)
Short circuit between TP1001 and Ground with the cable JG154.
(Refer to MAJOR COMPONENTS LOCATION GUIDE)
The EOT, BOT and Reel Sensor do not work at this moment.
At that time, the STOP/EJECT button is available to insert and eject the Cassette Tape.