Introduction
12
Operation:
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of approx. 5 meters.
Replace the compartment
cover.
Install two “R03/AAA” batteries
(supplied),
paying attention to the
polarity diagram in the battery
compartment.
Open the battery compart-
ment cover in the direction of
the arrow.
• Press POWER to turn the unit on or off.
• Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
•Tap CH
or to move through the channels one channel at a time.
• The Direction buttons (
/ / / ) are also used to navigate on-screen menu system.
•You can directly access specific channels using Direct channel selection buttons.
1
23
Remote control basics
Inserting batteries
Approx. 5 meters
Illustration of MW20F11
Identification of controls (Continued)
Caution:
•Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Attention should be drawn to the environmental aspects of battery disposal.
• Do not mix different battery types or combine used batteries with new ones.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace both
batteries with new ones.
• If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to
prevent battery acid from leaking into the battery compartment.
5T40301A [E]p06-12 3/1/05, 10:1512