Filter
Top Products
Simple wired remote controller
Owner’s Manual
–4–
EN
2 PART NAMES AND FUNCTIONS
Max. 8 indoor units can be operated by a remote controller.
Push each button to select a desired operation.
• The details of the operation needs to be set up once, afterward, the air
conditioner can be used by pushing ON/OFF button only.
Illustration of LCD shown below is for explanation. It may differ from the
actual LCD.
1 Fan Speed button
2 Mode button
3 Swing/Air direction button
The louver angle is changed.
4 Setup temperature button
Adjust the set point.
Set the desired set point by pushing
or .
5 ON/OFF button
6 Check button (Used in
servicing)
Do not use this button usually.
7 Remote control temperature
sensor
Usually controlled by the indoor unit
sensor, it can be changed to the
remote controller. For details,
contact the shop which you
purchased the air conditioner. (When
using a group control method, do not
use the remote controller sensor.)
SETTING
1
2
3
7
6
5
4
4-EN
+01EN.BOOK Page 4 Thursday, October 8, 2009 3:37 PM