Filter
Top Products
38
Setting details
Customizing the function settings (continued)
Function setup
Output
You can select the video output signal of the DVD
video player to the TV from “Interlace” or “Progres-
sive”.
1) Press C or D to select “Output”.
2) Press A, then press C or D to select “Interlace”
or “Progressive”.
Interlace:
Select when connecting to a composite TV or
a TV equipped with component video inputs
but progressive scan is not compatible.
Progressive:
Select when connecting to a TV equipped
with component video inputs, progressive scan
compatible.
3) Press ENTER.
Warning:
Once “Progressive” is selected when connecting to
a TV progressive scan incompatible, no image will
be seen on the video display.
In this case, you must reset the unit by pressing
STOP on the front panel for five seconds. The video
output will be restored to “Interlace” setting, and a
picture will once again be seen on a conventional
analog display.
Notes:
• Some discs may not be played back with the progressive
scanning mode correctly because of the disc characteris-
tics or recording condition.
• Once Progressive scan on, all other video outputs are
disabled except component video outputs.
Note:
If each setup (pages 35~38) has been completed, the unit
can always be worked under the same conditions
(especially with DVD discs).
Each setup will be retained in the memory even if you
turn the power off.
2F60201A [E] P34-38 2/22/05, 10:48 AM38