Filter
Top Products
ENG-13ENG-12
Choosing a Connection
Connection to a TV (For Video)
TV (Normal, Widescreen, Projection, etc..)
• Turn on your TV and set it to the correct Video Input by pressing TV/VIDEO button on.
Method 1
DVD Player + TV with Video Input Jack
(The Video Output must select the S-Video or 525i(480i) by setting Video select switch.)
Method 2
DVD Player + TV with S-Video Input Jack
(The Video Output must select the S-Video by setting Video select switch.)
Method 3
DVD Player + TV with Component Video Jacks
(The Video Output must select the 525i(480i) by setting Video select switch.)
Method 4
DVD Player + TV with Progressive Scan Jacks.
(The Video Output must select the 525p(480p) by Video select switch.)
• If you want to convert Video Output to the Progressive Scan, you have to first connect Video or S-Video on
your TV. Then select 525p(480p) by using Video select switch.
• If 525p(480p) Video Output is selected by setting Video select switch, Video(Composite) and S-Video will not
work.
• Our set do not have Video output setting in setup menu.
Important Note
• Consult your TV User’s Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User’s Manual’s instructions regarding Progressive Scan
settings in the TV’s menu system.
• Depending on your TV, the Method of connection may differ from the illustration above.
R - AUDIO - L
VIDEO S-VIDEO
Good
picture
Better
picture
Best
picture
Optimum
picture
Basic Audio
AV Cable
S-Video
Cable
OR OR
Video
Cables
Audio Output
Jacks
Video Output
Jack
S-Video
Jack
Component Video
Jacks
(Interlace)
Component Video
Jacks
(Progressive)
TV
DVD
Player
Method 1 Method 2 Method 3 Method 4
Choosing a Connection
The following shows examples of connections commonly used to connect the DVD player with a TV
and other components.
Before Connecting the DVD Player
• Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.
• If you connected an external Audio System, turn on your Audio System and set it to the correct Audio Input.
• Refer to the owner’s manual of the additional components you are connecting for more information on those
particular components.
Connection to an Audio System
Note
• In case of DVD-AUDIO, SACD playback cannot use Digital Audio Out.
• In case of SACD playback cannot use multi channel or 2 channel Digital Audio out. (See page 31~32)
Method 1 Method 2
R - AUDIO - L
R SURROUND L S/W
R FRONT L CENTER
ANALOG AUDIO OUT
Analog Audio Out
(2 Channel)
Analog Audio Out
(Multi Channel)
Digital Audio Out
2ch Amplifier
Audio Input Jacks
5.1ch Analog Amplifier
Audio Input Jacks
AUDIO
SYSTEM
DVD
Player
Method 3
COAXIAL
OPTICAL
Dolby Digital Decoder
Digital Audio Input Jack
OR
Toshiba-SD-6915 fix ok rev01 2004/6/04 07:30am Page 12