Filter
Top Products
62
Function setup (DVD)
Output
You can select the video output signal of the DVD
video player to the TV from “Interlace” or “Progres-
sive”.
Interlace:
Select when connecting to a composite TV or a TV
equipped with component video inputs but
progressive scan is not compatible.
Progressive:
Select when connecting to a TV equipped with
component video inputs, progressive scan
compatible.
Warning:
Once “Progressive” is selected when connecting to a
TV progressive scan incompatible, no image will be
seen on the video display.
In this case, you must reset the unit by pressing STOP
on the front panel for five seconds. The video output
will be restored to “Interlace” setting, and a picture will
once again be seen on a conventional analog display.
Notes:
• Some discs may not be played back with the progressive
scanning mode correctly because of the disc characteris-
tics or recording condition.
• Once Progressive scan on, S-video output is disabled.
Note:
If each setup (pages
59
~
62
) has been completed, the unit
can always be worked under the same conditions (espe-
cially with DVD discs).
Each setup will be retained in the memory even if you turn
the power off.
If you forget the password...
1) Press OPEN/CLOSE to open the disc tray.
2) Remove the disc.
3) Press OPEN/CLOSE again to close the disc tray.
“No Disc” appears on the screen.
4) While holding 7 down on the remote control and
then press STOP on the front panel. “Password
Clear” appears on the screen. Now the password
has been returned to the initial value (“0000”).
Setting details
Customizing the function settings (Continued)
2I30201B-En_p57-62 1/13/06, 2:51 PM62