Toshiba SD-V592SU DVD VCR Combo User Manual


 
Controlling Your Cable Box/DSS
®
Satellite Receiver
40
Setting Cable Box/DSS
®
Satellite
Receiver Control Codes
1. Press CABLE BOX to set the remote control
operating your Cable box/DSS
®
Satellite
Receiver.
2. While holding down PROGRAM button, enter the
two digits of your Cable box/DSS
®
Satellite
Receiver Brand Code (listed on page 41) using
number buttons.
3. Release PROGRAM.
Point the remote control at your Cable box/DSS
®
satel-
lite Receiver and use each button listed below to make
sure that your Cable box/DSS
®
satellite receiver is oper-
ated correctly.
By pressing You can
POWER Turn the Cable box/DSS
®
satellite
receiver on or off.
CH/TRK +/– To select Cable box/DSS
®
satellite
receiver channels in the upper or
lower direction, (Not applicable to
some brands of Cable box/DSS
®
satellite Receiver.)
Number buttons To select desired channels to
record.
ENTER To use for the Cable box’s Enter
Key.
(Some cable boxes require you to use 100 button as
the enter button.)
Note :
For some brands, several control codes (brand
codes) are allocated. Try each of them until the but-
tons work on your TV.
If you replace the remote control’s batteries, set the
brand code again.
CABLE BOX
POWER
PROGRAM
Number
buttons
100
CH/TRK
ENTER
Important
Some Cable box/DSS
®
satellite receiver may not
respond to all the operations above, or may not be
operated at all with this remote control. In this
case, operate them with its own remote control.