Filter
Top Products
32
■ Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Item Description
Computer Y/PB/PR
Video
DVI
S-video
Input Input source name Yes Yes Yes Yes
Mode name RGB input mode
[Note 1]
Ye s N o N o Ye s
H-resolution Horizontal resolution (in dots) Yes No No Yes
V-resolution Vertical resolution (in dots) Yes No No Yes
H-frequency Horizontal sync frequency Yes No No Yes
V-frequency Vertical sync frequency
[Note 2]
Ye s N o N o Ye s
Sync Sync signal polarity
[Note 3]
Ye s N o N o Ye s
Signal format Y/PB/PR signal format No Yes No No
Video mode Color method of video signal No No Yes No
Lamp time Time of lamp use
[Note 4]
Ye s Ye s Ye s Yes
Lamp reset count The count for lamp replacement Yes Yes Yes Yes
Total time
The total time that this projector is used
Ye s Ye s Ye s Yes
Version Firmware version
[Note 5]
Ye s Ye s Ye s Yes
Notes
1: The mode of supported RGB signals
p.39
is shown.
2: Same as the refresh rate of the computer signal.
3: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as
a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult
with a store about getting a TLPLMT20 replacement lamp (sold separately) prepared.
5: [Version] shows the version of the projector’s internal control program. This version is referred
to for customer service, etc.
Note
• The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
Using the menu (Continued)