Toshiba 19A20 CRT Television User Manual


 
17
Set up
Basic Operation
Advanced Operation
Reference Selection
To temporarily unblock programs
THIS PROGRAM HAS BEEN BLOCKED!
TV–PG L V
EXCEEDS SET LIMITS
PUSH MUTE TO ENTER PIN
CABLE 4
1 If you try to watch a TV program that exceeds the rating
limits you set, the TV will enter into the program block
mode.
BLOCKING IS ACTIVE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~–
SELECT[0-9] END[EXIT]
2 If you want to watch the blocked program temporarily,
press MUTE.
Press the Number buttons (0-9) to enter the 4-digit code
you have stored.
If the number is correct, the block mode will be released.
After 1 second, normal picture will appear.
All blocking is disabled until the TV is turned off.
It will be enabled when the power is reapplied.
If a wrong pin code is entered, the message appears.
Enter the correct code again.
INCORRECT PIN CODE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~~
SELECT[0-9] END[EXIT]
BLOCK CHANNEL function
With the CHANNEL BLOCK function, you can block spe-
cific channels. The TV will not be able to tune these channels
with the CHANNEL s/t buttons or Channel Number
buttons, unless you clear the setting.
This TV has 8 memory spaces total, 4 for TV mode and 4 for
CABLE mode.
To block channels
1 Select a channel you want to block.
BLOCK CHANNEL
SET CLEAR
15 10 6 2
SELECT[T S ] CLEAR[s t ]
END[EXIT]
S
0 0 0 0
ENABLE BLOCKING Y N
SET RATING
SET BLOCKING OPTIONS
NEW PIN CODE
BLOCK CHANNEL
MOVE[s t ] SELECT[T S ]
S
2 Select BLOCK CHAN-
NEL in the V-CHIP
CONTROL menu by
pressing t or s.
BLOCK CHANNEL
SET CLEAR
0 0 0 0
SELECT[T S ] SET[s t ]
END[EXIT]
S
BLOCK CHANNEL
SET CLEAR
0 0 0 2
SELECT[T S ] SET[s t ]
END[EXIT]
S
3 Press T or S to display
the BLOCK CHANNEL
menu.
4 Press T or S to select
SET, then press t or
s until the channel
number to be blocked
(2 in this example) re-
places 0 on the display.
5 Repeat steps 1 to 4 for other channels.
6 Select another channel before turning off the TV.
To restore channels
1 Select CLEAR follow-
ing the above steps 2 to 4.
2 Press t or s until 0
replaces the channel
numbers.
3 Press EXIT to erase the display.