Filter
Top Products
A
Remove it by pressing CALL.
Why is there a message permanently on the
screen?
Q
Below are the answers to some of the most common queries.
A
Check the mains switch is on and check all
connections.
Check the TV is not in standby mode.
Why is there no sound or picture?
Q
A
Check the volume has not been turned down or
that sound mute has not been selected.
Why is there a picture but no sound?
Q
A
Check the batteries aren’t dead or inserted
incorrectly.
Why doesn’t the remote control work?
Q
A
Check the Scart lead connection.
Why is there a good video picture but no sound?
Q
A
Make sure the VCR or DVD player is connected
correctly, then select the correct input by
pressing
B
.
Why doesn’t the video/DVD being played show
on screen?
Q
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be achieved. The
colour is factory set to AUTO to automatically display the
best colour system.
To check that you have the best colour:
There IS a picture, but why is there little or no
colour?
Q
With the external source playing, select COLOUR
from the SET UP menu.
With
S
or
R
choose between AUTO, PAL,
SECAM, NTSC, 4.43 or 3.58.
1
2
?
For television
operation queries,
please ring the
helpline…
Remember…
F
o
r
U
K
o
n
ly
Questions and Answers
For quick reference
to topics, see the
INDEX at the back
of this manual.
15
A
Interference or a weak signal. Try a different TV
station. MANUAL FINE TUNING (MFT) may help.
What else can cause a poor picture?
Q
A
Good performance of text depends on a good
strong broadcast signal. This normally requires a
roof or loft aerial. If the Text is unreadable or garbled,
check the aerial. Go to the main index page of the teletext
service and look for the User Guide. This will explain the
basic operation of teletext in some detail. If further
information is needed on how to use text see the
teletext section.
Why are there problems with teletext?
Q
A
There are none broadcast or they have not yet
loaded. Press the
X
(
B
)
button to access.
(See teletext section).
Why are there no teletext sub-pages?
Q
A
Connect the source via a Scart lead and play.
Select COLOUR from the SET UP menu.
Why are the colours wrong when an NTSC
source is played?
Q
Set the Colour to AUTO and exit.
Go to the PICTURE menu and adjust the tint.
1
2
SET UP
COLOUR
z AUTO x
SYSTEM z I x
ASM zx
RRR
zx
POSITION z P00 x
MEMORY OK x
e