Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
11
(E) 30HF83
Connecting a DTV receiver/set-top box with
component video and a VCR
This connection allows you to watch DTV (digital TV), VCR, and
TV programs, and record DTV and TV programs.
Your TV has ColorStream (component video) inputs. Connecting
your TV to a DTV receiver with component video inputs can greatly
enhance picture quality and realism.
– To record and watch a DTV program, select LINE IN on the
VCR, and select ColorStream HD-2 (or VIDEO 1 for a non-
ColorStream connection) on the TV (see “Selecting the antenna
input” on page 21).
– To record a TV program while watching a DTV program, tune the
VCR to the channel to record, and select ColorStream HD-2 on
the TV.
– To record and watch the same TV program, tune the VCR to the
channel to record, and select VIDEO 1 on the TV.
– To record one TV program while watching another TV program,
tune the VCR to the channel to record, and tune the TV to the
channel to watch.
You will need:
• three coaxial cables
• two sets of standard A/V cables
• one pair of audio cables
• one set of component video cables
OUT
IN
ANT
(
75
)
ANT-1 ANT-2OUT
L/
MONO
AUDIO
VIDEO
S-VIDEO
VIDEO 1
PB
PR
Y
COLOR
STREAM HD-1
COLOR
STREAM HD-2
R
VIDEO
S-VIDEO
VIDEO 2
L/
MONO
AUDIO
VIDEO
R
L
VAR
AUDIO
R
AUDIO
R
L
PB
PR
Y
AUDIO
R
L
L/
MONO
AUDIO
R
ONOFF
AUDIO CENTER
CHANNEL IN
DVI/HDCP IN
R
AUDIO
L
IN from ANT
VIDEO AUDIO
OUT to TV
CH 3
LR
CH 4
IN
OUT
VIDEO
OUT
S-VIDEO
AUDIO
COMPONENT VIDEO
OUT
L
R
L
R
P
R
P
B
Y
Satelite IN
DTV Receiver with component video
Stereo VCR
From
Antenna
From
DTV Antenna
TV
Note:
For the highest possible picture quality, use
component video cables (or a DVI-D single-
link cable) between TV and DTV receiver. You
can connect the component video cables to
either set of ColorStream jacks on the TV
(HD-1 or HD-2).
The ColorStream HD-1 and HD-2 jacks can
be used with Progressive (480p, 720p) and
Interlaced (480i,1080i) scan systems. A 1080i
signal will provide the best picture
performance.
If your DTV receiver does not have
component video (or DVI-HDCP video), use
the S-video and standard audio connections
instead. Do not connect both an S-video and
a standard video cable to VIDEO1 (or
VIDEO2) at the same time or the picture
performance will be unacceptable.
For DVI/HDCP connection, see page 13.
To monitor recording, set the TV to VIDEO 1.
The unauthorized recording, use,
distribution, or revision of television
programs, videotapes, DVDs, and other
materials is prohibited under the
Copyright Laws of the United States and
other countries, and may subject you to
civil and criminal liability.