Filter
Top Products
52
(E) 46/52/62HM95
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Chapter 6: Setting up your TV
To view the system status:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown
below right).
Navigate
Select
Back Exit
CH RTN
EXIT
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
Auto
2 Sec
15 min
HDMI 2 Audio
Slide Show Interval
AVHD Skip Time
Setup
Navigate
Select
Back Exit
CH RTN
EXIT
System Infomation
System Status
3. Open the System Status menu, highlight System
Information, and then press ENTER.
4. Use the x • buttons to scroll through the menu bar to
check the Product Information and Software Version.
System Information
O K
Brand:
Model:
IEEE1394 GUID:
Toshiba
52HM95
00003914-28343803
Product Information
System Information
O K
0.3.0
Mar 9 2005 - 12:37:10
FW:0.12
Sub:47
Software Version
To close the screen and return to the Installation menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Use the x • buttons to scroll through the menu bar to
select Factory Defaults.
3. Enter your PIN code (or 0000 if no PIN code has been set).
4. Highlight Yes and press ENTER. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
To cancel the reset:
Highlight No and press ENTER.
Viewing the system statusViewing the digital signal meter
You can view the digital signal meter for the ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Navigate
Select
Back Exit
CH RTN
EXIT
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
Auto
2 Sec
15 min
HDMI 2 Audio
Slide Show Interval
AVHD Skip Time
Setup
3. Open the Terrestrial menu, highlight Signal Meter, and
press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate
Select
Back Exit
CH RTN
EXIT
4. Use the yzx • buttons to select the antenna input and
digital channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Antenna 1
Physical Digital Channel 13
Virtual Digital Channel
O K
N/A
Signal Locked
0
0
Peak
To close the screen and return to the Terrestrial menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
HM95_R1_044-52_061505 6/24/05, 9:48 PM52
Black