Filter
Top Products
12
Programming the remote control for use with
a cable TV converter/satellite receiver, VCR or
DVD player
This remote control is pre-programmed to operate Toshiba satellite
receivers, VCRs and DVD players. To control cable TV converters/
satellite receivers, VCRs and DVD players other than Toshiba models,
you must follow the steps below to program your remote control.
1. Refer to the code tables (on pages 13 and 14) to find the
corresponding code for your brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Set theTV • CBL/
SAT • VCR • DVD selector to “CBL/SAT.”
• VCR: Set the TV • CBL/SAT • VCR • DVD selector to “VCR.”
• DVD player: Set the TV • CBL/SAT • VCR • DVD selector to “DVD.”
3. While holding down RECALL, press the Channel Number buttons
to enter the three-digit code for your cable TV converter/satellite
receiver, VCR or DVD player brand.
4. Point the remote control at the cable TV converter/satellite
receiver, VCR or DVD player, and press POWER to test the code.
• If the cable TV converter/satellite receiver, VCR or DVD player
responds, you entered the correct code.
• If the cable TV converter/satellite receiver, VCR or DVD player
does not respond, repeat steps 1–4 using another code.
5. Set the TV • CBL/SAT • VCR • DVD selector to “TV” to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code _____________________
VCR code ______________________________________________
DVD player code _________________________________________
Notes:
• When shipped from the factory, the remote
control is set to operate your TV.
• If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed below, this operation is canceled.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and does
not respond to any of the codes for your
VCR, set the switch to the other position
(VCR1 or VCR2) and reprogram the remote
control.
Using the
Remote Control
TV • CBL/SAT
• VCR • DVD selector
Recall
Channel
Numbers
Program the remote
control to recognize the
brand of your DVD
player (see
“Program
ming the
remote control
for use
with a cable TV
converter/satellite
receiver, VCR or DVD
player” below). The
buttons shown at right
will then control the
DVD player.
Set the TV • CBL/SAT •
VCR • DVD selector to
“DVD” first.
Power
Number
buttons
DVD Skip/Search /
TV • CBL/SAT • VCR
• DVD selector
Display
DVD Clear
TOP Menu
ENTER
DVD MENU
Pic Size (TV)
Mute (TV)
Light
Input (TV)
Volume ▲▼ (TV)
DVD controls
To control a DVD player:
▲▼
▼
▼
3N11601A/E P07-17 1/19/04, 6:01 PM12