Filter
Top Products
Programming the Remote Control
• This Remote Control is preprogranuned to operate TOSHIBA VCR's.
V '
• To use CR s other than TOSHIBA models (or cable coilvertel'), perfornl the following procedures before
operating.
POWER
®@
®
I
®i
I
i
!
J
!
I
I
TOSHIBA
RECALL
-- Number
Controlling other brands of VCR's and cable TV converters
] Ref'cr to the "VCR code table" (or "'Cable TV converter code
table") Oll pages 12 alld 13 to find the code IILIH3bcIINHIcorresponds to
the brand IILIlllC el'your V(R (or con\ ellci ).
[tnlore thai1 t)llC IlUil/hel is listed, Ii} oath one s0paratcl} until you lind
the one thai \\ ork_,.
2 Set the TV/CABLE/VCR switch to "'V('R'" (o1 "'CABLE").
3 I lold down RECALL while pressing the Number buttons for tile three
digit code lc nbe" fo" yet r b and c t"VCR (€ r cc nvei_er)
4 Point the Remote Control tit the V('R (or tit Ille converter) and press
POWER to test the code number.
-If the right number ',','as entered, the \"CI'_ (or the con',erter) should
turn ofT.
IIfthe VCR (or the converter) does not respond to the Remote
Control, repeat steps I to 4 with another code number.
Reset tile TV/CABLENCR switch to '<TV'" to control the TV.
For I'uttlre reference, write down the code numbers yell used:
VCR CODE
CABLE CODE
Notes:
• Yo!I ]l(ll:(d to I'_/)Pogl'_lfl! I/l_: Relllo((." CoII!I'O/llh(_ll Felt (hallg(" it_ [)(IHL:/'ie,_.
• Soltw n¢lr_,vI'('R '_tu'_,_af)able o/workillg o_t_ith_,/'o/m.o r_,mnt_,_odes. The,se
IT'R _ hal'u a _ltitch/alwl_,d "I'(.NI/V('R2 ".
I/)'our I (-LRhm //li_ 4ind q/ slritdz, .ml *h_'._no! vu.vpomlm all the cod*, nuolhur,_
/br.l'om" lzCRhs'andname,,_t't t/w ,_lvllch re anoth_,r/_o._'ifiml(" VL'R] "'or "V('R2 "')
_111(/ I'(']H'O_._/'HIII 1[11_ ]_UHIOt(' _'fHItI'O[
11