Filter
Top Products
19
Connections
VIDEO
SUBWOOFER SURROUND
FRONT
CENTER
COAXIAL OPTICAL
S
L
R
AC IN
VIDEO OUT
Y
P
B
PR
AUDIO OUT
5.1CH
SURROUND
2CH
BITSTREAM
/PCM
Notes
• Refer to the owner’s manual of the connected equipment as
well.
• When you connect the DVD player to other equipment, be
sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD player near a tuner or radio, the radio
broadcast sound might be distorted. In this case, place the
DVD player away from the tuner and radio.
• The output sound of the DVD player has a wide dynamic
range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, the speakers may be damaged by
a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the
DVD player’s power cord. If you leave the amplifier power on,
the speakers may be damaged.
Connecting to an audio system and TV equipped with component video inputs
Signal flow
To wall outlet
To audio inputs of
the amplifier
(red)
(white)
(red)
(white)
To Y
VIDEO
OUT
To PB
VIDEO
OUT
To P
R
VIDEO
OUT
To PR video input
To P
B video input
To Y video input
TV or monitor with component video
(PROGRESSIVE) inputs
or
TV or monitor with component video
(INTERLACED) inputs
Audio system
PROGRESSIVE outputs/inputs (ColorStream
®
Pro)
Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal. Connecting to these inputs allows
you to view the highest quality pictures with less flicker.
INTERLACED outputs/inputs (ColorStream
®
)
Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB,
CR)
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.
To switch the output signal (Progressive/
Interlaced)
Press COLOR STREAM SELECTOR on the remote
control.
The output signal alternates between component
progressive and component interlaced.
• Make the following setting.
On-screen display
Select:
Page
“Analog 2ch”
“Audio Out Select”
To 2CH AUDIO OUT
54
58