Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
13
Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most VCR
models, and cable TV converters together, even if they are different
brands. If you will be using your TV with a Toshiba VCR, your
remote control is already programmed and ready to use. If you own
different brands of VCRs and/or converters, you first have to program
your remote control. (See “Programming the remote control for use
with a non-Toshiba VCR or a cable TV converter” on page 14.)
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off of the back of the remote control.
2. Install two “AA” size alkaline batteries. Match the + and - signs on
the batteries to the signs on the battery compartment.
3. Slide the battery cover back on to the remote control until the
lock snaps.
Using the remote control with a
VCR or a cable TV converter
To control a VCR:
Set the TV/CABLE/VCR switch to the VCR position. The
shaded buttons shown at right will control the VCR. The
unshaded buttons will operate the TV as usual.
To control a cable TV converter:
Set the TV/CABLE/VCR switch to the CABLE position. The
shaded buttons in the top part of the illustration at right will
control the cable TV converter. The other buttons will operate the
TV as usual.
If you own a non-Toshiba VCR or cable TV converter, see
“Programming the remote control for use with a non-Toshiba VCR or
a cable TV converter” on page 14.)
Note:
Your TV’s remote control may or may not
operate your VCR or cable TV converter.
Refer to the owner’s manuals supplied with
your other equipment to see which features
are available. In addition, the original
controllers may have features not available on
this remote control. If you would like to
continue to use these features, you may want
to use the original remote control.
Caution:
• Dispose of batteries in a designated
disposal area. Do not throw batteries into a
fire.
• Do not mix battery types or combine used
batteries with new ones.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• If you do not intend to use the remote
control for a long time, remove the
batteries.
123
456
789
ENT
100
0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO
MUTE
TV
CABLE
VCR
CH RTN
MENU
EXIT
LIGHT
STOP SOURCE
ADV/
PIP CH
ADV/
PIP CH
FAV
FAV
PLAY PIP
REC TV/VCR REW FF
STILL LOCATE SWAP
C.CAPT
RESET
ENTER
TV/CABLE/VCR
POWER
Channel yz
Chanel
Number
Enter
PLAY
STOP
Fast Forward
Rewind
TV/VCR
Record