Filter
Top Products
Setting TV Control Codes
1
Press
TV
to set the remote control operating your TV.
2
3
Release
PROG
.
4
Point the remote control at your TV and use each button
listed below to make sure that your TV is operated correctly.
POWER
To turn the TV on or off.
CH/TRK
To select TV channels in the upper or lower
direction.
TV VOL
To adjust the sound level.
I.SELECT
To select an external source such as a VCR.
Number buttons
To select TV channels. When selecting channels
1 to 9, first enter 0 and then the desired number.
100
To substitute for 100 channel key.
DISPLAY
To turn on or off TV’s screen display.
ENTER
To use for the TV’s ENTER key.
TV
VCR
PROG. ENTER
TV/VCR
POWER
CH/TRK
TV VOL
I.SELECT
REMAIN/
COUNTER
DISPLAY
COUNT RESET
SP/SLP
REC
TIMER
SLOW
PLAY/x2
PAUSE/STILL
REW FF
CURSOR
STOP
CANCEL
A.SELECT
EJECT
CM SKIP
1
2
3
456
7
8
9
0
100
1
POWER
CH/TRK
TV VOL
100
Number
buttons
DISPLAY
I.SELEC
T
ENTER
2, 3
While holding down
PROG.
enter the two digits of your TV’s
brand code (listed on page 30 ) using
number buttons
.
29
Important
Some TV’s may not respond to all the operations above, or
may not be operated at all with this remote control. In this
case, operate your TV with its own remote control.
Notes
• For some brands, several control codes (brand codes) are allocated. Try
each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code again.
ADDITIONAL INFORMATION
ADDITIONAL INFORMATION
Multi Brand Remote Control
The remote control can be compatible with various brands of TV by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
W-627 Eng(29-36) 2/28/02, 3:30 PM29