Filter
Top Products
20
Adjusting the tracking
When playback starts, the VCR
automatically adjusts the tracking for clear
pictures and sound (Digital Auto Tracking).
The “DT” indicator blinks during the
adjusting.
If the VCR cannot locate the best possible
tracking point, hold down one of
CH/TRK
to
adjust the tracking manually.
• To resume the digital auto tracking, hold
down both
CHANNEL
on the VCR
simultaneously for about 2 seconds.
Notes
• During the adjusting, the playback picture and
sound may be distorted.
• The digital auto tracking is activated only in the
playback mode.
• To reset the manual tracking point to the center,
press both
CHANNEL
on the VCR
simultaneously for not longer than 1 second.
• The noise on the screen may not be completely
eliminated depending on the tape used,
especially when the tape was recorded on
another VCR.
19µ HEAD
You can view high quality pictures while
playing back a tape recorded in the SLP tape
speed.
By pressing
19
µ repeatedly, the 19µ HEAD
mode is displayed on the TV screen as
follows:
19U-HEAD AUTO: Usually set to “AUTO”. As
the playback starts, the VCR automatically
activates the 19µ head and reproduces high
quality pictures.
19U-HEAD OFF: Set to “OFF” if the
pictures are marred by dots.
Note
During playback with the 19µ head, momentary
noises or shakes may be produced when you
change the mode to the picture search or
variable speed playback.
Basic Playback
1
Load a recorded cassette.
Power is turned on.
If the cassette has no safety tab,
playback starts automatically.
2
Press
PLAY/x2
to start playback.
3
To stop playback, press
STOP
.
Rewinding / Fast-forwarding
Press
REW
or
FF
in the stop mode.
POWER
PLAYBACK
Playback
This section explains the basic playback operation.
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
• Press
VCR
to set the remote control operating the VCR.
VCR
SP
DT
POWER
78
0
100
9
65
23
4
1
STOP
PLAY/x2
FFREW
3
2
FF
CH/TR
K
VCR
REW
19
µ