Filter
Top Products
28
PTZ CAMERA SETUP
Note IPSe recorders support only select IP PTZ cameras.
Select PTZ cameras can be configured and controlled using the Surveillix recorder software. For instructions on configuring and installing
your PTZ camera, refer to the camera manual.
Enabling an Analog PTZ Camera
1. Ensure that you have properly connected your IP PTZ camera to the network.
2. On the Display screen, click Setup.
3. Click IP Cameras, and then click Advanced Camera Setup.
4. Click Select Channel, and then click the analog channel you want to enable as a PTZ camera.
5. Select Enable Pan Tilt Connection.
6. Type the appropriate Protocol, Port, Baud Rate, Parity, Data Bits, and Stop Bits for your analog PTZ camera. These must
be the same settings that have been configured on the camera itself.
7. Set the appropriate General and Preset/Tours options
8. Click Apply to save your settings.
Enabling an IP PTZ Camera
9. Ensure that you have properly connected your IP PTZ camera to the network.
10. On the Display screen, click Setup.
11. Click IP Cameras, and then click the Advanced Camera Setup tab.
12. Select the IP camera form the Network Cameras Currently in Use list.
13. Select PTZ Camera.
14. Click Apply to save your settings.