Filter
Top Products
2
SBFTF10xx-15x
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when setting the 4-position switch. Failure to observe this caution
could result in damage to, and subsequent failure of, the media converter.
Set the 4-Position Switch
• The 4-position switch is located
on the side of the media
converter.
• Use a small flat-blade screwdriver
or a similar device to set the
recessed switches.
• Refer to the drawing for the
locations of the four individual
switches.
1. Auto-Negotiation
Up Enables Auto-Negotiation on the copper port.
Advertises 100 Mb/s full-duplex and half duplex,
and 10 Mb/s full-duplex and half duplex.
Down Disables Auto-Negotiation on the copper port.
2. Copper Mode
(Applies only if switch 1 is down.)
Up Forces full-duplex operation on the copper port.
Down Forces half-duplex operation on the copper port.
3. Speed
(Applies only if switch 1 is down.)
Up Forces 100 Mb/s operation on the copper port.
Down Forces 10 Mb/s operation on the copper port.
4. Fiber Mode
Up Forces full-duplex operation on the fiber port.
Down Forces half-duplex operation on the fiber port.
Speed (up=100Mb/s)
Copper Mode (up=Full-Duplex)
Auto-Negotiation (up=Enabled)
Fiber Mode
(up=Full-Duplex)
1234
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
3
Installation -- Continued
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when setting the jumper. Failure to observe this caution could
result in damage to, and subsequent failure of, the media converter.
Set the Jumper
The Far-End Fault jumper is labeled “FE” for enable
Far-End Fault and “FD” for disable Far-End Fault (see
page 6).
Enable A fault on the fiber link causes the media
converter to transmit a Far-End Fault signal.
Disable No Far-End Fault signal is transmitted when
a fault occurs.
To set the jumper:
1. Using a small screwdriver, remove the four (4) screws that secure the
cover and carefully remove the cover from the media converter.
2. Locate the jumper on the circuit board labeled “FE” and “FD”.
3. Using small needle-nosed pliers or similar device, move the jumper to
the desired position. (Refer to the drawings above.)
4. Carefully replace the cover on the media converter and replace the four
(4) screws that secure the cover to the media converter.
Disable Far-End Faul
t
Enable Far-End Fault
FE FD
FE FD