Filter
Top Products
SGETF10xx IN THE NETWORK
Install two SGETF10xx series media converters in series to extend, over fiber,
the distance between two 1000BASE-TX devices.
Use one SGETF10xx media converter to connect a 1000BASE-TX terminal
device and a 1000BASE-SX/LX hub, switch, or router.
NOTE: A TRANSITION Networks stand-alone media converter can be installed
in series with a TRANSITION Networks chassis media converter that has a
related model number, such as an SGETF10xx with a CGETF10xx.
INSTALLATION
Set 4-Position Switch
Use small flatblade screwdriver or similar device to set recessed switches.
Refer to drawing for four-position switch locations.
Full/Half-Duplex Advertisement (UP=Enabled) Allows full-duplex mode.
(DOWN) Allows half-duplex mode.
Pause Advertisement (UP=Enabled)
Allows auto-negotiation pause. (DOWN)
Allows NO auto-negotiation pause.
NOTE: If the Pause feature is present on
all network devices attached to the media
converter(s), enable Pause on the media
converter(s). Otherwise, disable Pause on the media converter(s).
LPT (UP=Enabled) Allows a fault EITHER on the copper OR on the fiber side
of the media coverter to stop signal and data transmission on the other side.
(DOWN) Disables LPT.
TECHNICAL SPECIFICATIONS
Standards IEEE 802.3ab, IEEE 802.3 1998
Data Rate 1000 Mb/s
Dimensions 3.4" x 0.86" x 5.0" (86mm x 22mm x 127mm)
Weight 8 oz (approximate)
Delay 300 nsec
Power Consumption 6.5 Watts
Power Supply Requirements Replace power supply with only the equivalent
input rating (see below) and output rating (unregulated 9-24VDC, 5.5W).
TN PN Requirement Location
12 V, 1.5 A
3507 240 volts, 50 hertz United Kingdom
3342 230 volts, 50 hertz Europe
3340 120 volts, 60 hertz USA/Canada/Mexico
3346 100 volts, 50-60 hertz Japan
3511 240 volts, 50 hertz Australia
3537 IEC320 (with power cord: 3522) South Africa
9 V, 1 A
25039 IEC320, 90-250VAC input NOTE: Requires
appropriate IEC320
power cord for location
25040 120 volts, 60 hertz USA/Canada/Mexico
Environment Typical Operating Temperature*: 0°to 50°C (32° to 122°F )
Storage Temperature: -20°
to 85°C (-4°to 185°F)
Humidity 10-90%, non condensing
Altitude 0-10,000 feet
Warranty Lifetime
DECLARATION OF CONFORMITY
Name of Mfg: Transition Networks
6475 City West Parkway, Minneapolis MN 55344 USA
Model: SGETF10xx-100 Series Media Converters
Part Number(s): SGETF1013-100, SGETF1014-100, SGETF1015-100,
SGETF1017-100
Regulation: EMC Directive 89/336/EEC
Purpose: To declare that the SGETF10xx-100 to which this declaration refers is
in conformity with the following standards.
EMC-CISPR 22: 1985 Class A&B; EN 55022: 1988 Class A&B; EN 50082-1:1992;
EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950
I, the undersigned, hereby declare that the equipment specified above conforms to the
above Directive(s) and Standard(s).
_ January 6, 2001_____
Stephen Anderson, Vice-President of Engineering Date
Not Used
LPT UP=ON
Pause Advertisement UP=ON
Full/Half-Duplex Advertisement UP=ON