Filter
Top Products
- 5 -
Tuning your TV to the Sat-receiver:
Put the switch Test/TV on the backside of the set to position TEST. The signal of the
sat-receiver is tuned for channel 38(UHF) ex factory. Turn on your TV and tune it with
the channel search (UHF area) to the test signal. The test signal exists of two vertical
white stripes on black background. Memorize this tuning on an unused program on
your TV. You can later receive the satellite on this program.
If needed, please use the operation manual of your color TV.
Remark: If your channel 38 is used by a program, which you receive via an antenna
or another connected set, for example a video recorder, you can tune on the output of
the receiver between 30-39 UHF.
Turn with a small screwdriver carefully the signed output on the back of the set. With
this process you can change the channel of the starting signal of the sat receiver. In
this way you can tune channels 30-39. Tune again your TV for the RF signal and
memorize this adjustment.
Scart socket:
When you additionally connect your set with a scart cable, the satellite programs will
be directly fed in the TV, respectively the video receiver, as far as you have chosen the
AV channel of these sets. The picture and sound quality will be improved better. During
the operation over the scart cable there is no special adjustment needed.
Audio Output socket:
The audio sockets are used to connect the sat-receiver to a hi-fi set. So you can lis-
ten to the TV sound or one of the numerous radio stations via your set or respectively
record on a cassette recorder.